Function should come before frills and the PLINIUS 9100 exemplifies this notion.

It is a purpose built design where each material or component choice has been made always aiming for the maximum possible performance.

Power is an important part of this amplifier's character and with a generous 120 Watts per Channel the 9100 should satisfy even the most demanding applications.
In fact you may never approach the maximum output of the 9100 but if required there is comfort in the fact that it is there and available. The circuit of the 9100 is based on the PLINIUS Odeon Amplifier Module and shares the much praised PLINIUS House sound.

The 9100 is a specialist amplifier ready to combine with the abilities of a new generation of components from specialists around the world. It will prove revealing of any improvements made at source in a system and has the ability to drive any worthwhile loudspeakers with authority and finesse.

Although designed primarily for high quality reproduction of music, the 9100 will enhance the performance of both home theatre and multi-room systems by virtue of its flexible design.

Specifications

Power: 120 Watts RMS per channel into 8 Ohms. Both channels driven from 20Hz to 20kHz at less than 0.1% total harmonic distortion.

Frequency Response: 20Hz to 20kHz � 0.2dB. 0dB at 0Hz and -3dB at 70kHz.

Distortion: Typically <0.05% THD at rated power. 0.1% THD & IM worst case prior to clipping.

Current Output: 20A short duration peak per channel. Fuse protected.

Slewing: 50V/us

Hum & Noise: 90dB below rated output 20Hz to 20kHz unweighted.

Input Sensitivity: 290mV RMS for rated output at 1kHz.

Input Impedance: 47k Ohms.

Input Overload: 5V RMS

Rated Pre Out Level: 1.5V RMS into 47k Ohms or higher.

Pre Out Source Impedance: Typically 1.5k Ohms.

Pre Out Minimum Recommended Load: 47k Ohms

Tape Output Level: Unity Gain at 200mV. Tape loop muting at 5V RMS input.

Dimensions: Height 105mm (4"), Width 450mm (17.75"), Depth 400mm (15.75"), Weight 10kg (22lb)